HOW TO INSTALL TRANSMISSION PUMP STATOR FREE
verify free movement back and forth of stud thru flywheel. rotate converter to align converter stud with holes in flywheel, ensure drain plug on converter aligned with hole in flywheel. (5) After Transmission is bolted with all (6) or more bolts, ensure all bolts are tight about 40 ft.lbs. Note: Never use bolts to pull transmission up to engine block!
(4) Ensure Converter stays in this position during installation, “Warning” If converter moves forward, converter can move on top of the pump gears, this will cause the converter to crush the gears into the pump assembly when transmission case bolts are tightened to engine block. To verify converter is installed all the way, you should have clearance between the front of the transmission bell housing and the back of the torque converter Stud, about 1/2 of an inch. The forward drum shaft will engage first, you may feel a clunk, continue to rotate and push converter into transmission, The pump stator shaft will engage next and finally the converter hub will engage into the pump gears, you may feel another clunk. Rotate converter in a clock wise rotation as you push converter into transmission. (3) Install Converter on transmission carefully support the weight of converter to avoid damage to the pump seal. (2) Add (1) quart of transmission fluid to converter prior to installation of transmission. (1) Transmission Fluid: you need about 10 to 12 quarts of fluid for installation, Dextron III with Mercon, 1968 – 1993 Vehicles and Merand Newer, any brand name. “Warning” Transmission will suffer permanent damage if grounded improperly! (7) Clean area of block so transmission can make a good ground. (6) Ensure Block Plate is aligned and straight. (5) Inspect and verify both dowel pins are clean and secure in block. (4) Inspect back of engine block where transmission mates, ensure block is clean, no wires or cables are in the way of installation. (3) Check Flywheel for cracks and converter bolt holes for wear. (2) Inspect crank well for converter hub wear, and clean this area. (1) Pre-installation instructions Disconnect Battery terminal, inspect and check transmission coolant lines for damage, flush lines and coolant system thoroughly.
HOW TO INSTALL TRANSMISSION PUMP STATOR PROFESSIONAL
Please Note: The following instructions were made to act as a guide/reference, if you are inexperienced with performing an automatic transmission installation it is highly recommended that you contact a certified experienced professional to perform the installation and/or make the proper adjustments for you!
0 kommentar(er)
